Engine Bay Cleaning | Tips for Improved Performance
Extend Engine Life with this simple Engine Bay Detailing routine
Most people often miss out on the cleaning of their vehicle's engine bay and electronic components when washing or detailing their car. Visiting the car wash or scheduling a weekly detailing routine is a common habit for many drivers, but cleaning the engine bay often gets neglected for several reasons.
The most frequent excuse is the fear of causing harm to essential components, and being that engines are typically an “out of sight, out of mind” part of the vehicle, it shouldn’t matter anyway.
The truth is that cleaning your engine bay is highly important to maintain your car's performance, fuel consumption, and longevity. On older vehicles, a filthy engine bay can complicate the process of identifying fluid leaks. The presence of thick layers of grime, road salt, engine fluids, and rust can accelerate the degradation of rubber components such as vacuum lines and hoses.
Engine deposits can lead to poor performance and up to 5% lower fuel mileage. But, when these areas are properly cleaned, it can boost your car's performance.
BClean | Engine Steam Cleaning Process, Tips & Tricks 🧙🎩
Step 1: Prepping for Action
Start with a cold engine. Cleaning a hot engine can cause rapid cooling, which may lead to damage. Cover sensitive areas like the alternator, air intake, and electrical components with plastic and secure them with tape.
Step 2: Dust Removal 🧹
Begin by using a brush to gently remove loose dirt, leaves, and debris from the engine bay. This step is like giving it a quick sweep before deep cleaning.
Step 3: Applying Engine Cleaner 🧽
Spray a high-quality engine cleaner or degreaser generously over the entire engine bay. Make sure to cover all areas, especially those with visible grease and oil build-up. Let the cleaner sit for a few minutes
Step 4: Scrubbing Away 🧤
Using a brush, gently scrub away the dirt and grease. Focus on areas that need extra attention for those hard-to-reach spots. A steam cleaner will effortlessly dissolve built-up grime without causing any damage.
Step 5: Rinse and Repeat 💧
Rinse off the cleaner thoroughly with a gentle stream of water. Be cautious not to use high-pressure washers. Repeat the rinsing process until the water runs clear and all the cleaning residue is gone.
Step 6: Drying It Right 🫧
Dry with a clean microfiber cloth or towel. Ensuring it's completely dry prevents water spots.
Step 7: Unveil the Beauty ✨
Remove the plastic bags and tape from the protected components.
Marvel at the transformation! Your engine bay is now sparkling clean, and ready to hit the road again.
KEY TAKEAWAYS
• Ensuring the cleanliness of your engine bay is crucial for maximizing your car's performance, fuel efficiency, and overall lifespan.
• Steam cleaning the engine includes steps like blowing debris, applying degreaser, steam cleaning, and protecting components.
• Professional assistance is recommended if necessary.
• Give your engine bay the attention it deserves, and you'll not only drive in style but also enjoy a more reliable and efficient ride.
